Welcome to the DDMALL forum.

You are currently viewing our boards as a guest which gives you limited access to post questions and access to our other features.
Only registered members may post questions, download the updated firmwares and documents.

Registration is fast, simple and absolutely free so please - Click to REGISTER!

Summary of common use questions of HE-15

Add a discussion topic or ask a question about HE-20, HE-20IR here from your fellow HDMI extender users.
Post Reply
Posts: 39
Joined: Mon Dec 23, 2019 8:24 am

Summary of common use questions of HE-15

Post by DDM_Jim » Tue Feb 11, 2020 7:20 am

In this topic, we will list some questions you may encounter when using HE-15. If you encounter similar questions when using HE-15, you can refer and solve them quickly.

Question one:When using HE-15 for video transmission,the display device cannot receive signals.The TX of the HE-15 is connected to the video source and the RX is connected to the receiver.The TX and RX are connected using a 100-foot network cable,both sides are using USB power.Green light is always on, yellow light is blinking.

Answer:This can be caused by two reasons.
1.The source is HDCP vedio source, but the monitor does not support HDCP. At this point, the display will be blank, but the signal light on the display will light (indicating that a signal has been detected).
2.There is a problem with transmission link.

Suggestions for solving the problem
1.Check the status of the monitor. Whether the monitor has detected an input signal. If the monitor has detected an input signal but the screen is blank, we recommend replacing the HDCP-capable monitor.
2.Check the wiring sequence and crimping status of the network cable connected to the TX and Rx,network cable crimping should use T586A or T586B at the same time.
3.You can try to power only the TX side and see if it resolves.

Posts: 7
Joined: Sun Aug 09, 2020 12:21 pm
Location: Guatemala

Summary of common use questions of HE 15

Post by Lindatuh » Mon Aug 10, 2020 11:07 am

What are the most common commands you use in Linux? I know easy ones like free and top. But What are some of the others that you like to use?
Blog about your pc and viruses on it

Post Reply