Reminder

Welcome to the DDMALL forum.

You are currently viewing our boards as a guest which gives you limited access to post questions and access to our other features.
Only registered members may post questions, download the updated firmwares and documents.

Registration is fast, simple and absolutely free so please - Click to REGISTER!

Quick start guide for HDMI encoder

Post Reply
lupl
Posts: 2
Joined: Thu Nov 28, 2019 9:38 am

Quick start guide for HDMI encoder

Post by lupl » Tue May 19, 2020 4:18 am

Dear Customer,Thank you for purchasing the HDMI encoder,please read these quick start guide before operation.

1.System connection

A. Connect the encoder's HDMI input to your HDMI source.
B. Connect the encoder to the LAN port of the router or switch via an network cable.
C. Connect your control terminal (e.g. PC,ipad,iphone) to the same router or switch as the encoder.
D. Power on the encoder. The encoder can be directly powered from most HDMI source,While for some devices with low-power HDMI port, please use the included USB cable to power on the encoder.
E. The green light of the encoder network port is steady, indicating that the encoder is booting normally. The orange light flashes,indicating that the encoder is connected to the network normally.

How to connect the control terminal to the HDMI encoder:
viewtopic.php?f=50&t=3433;

Tips: Please make sure your control terminal is on the same LAN as the encoder.

2.Change the IP address of your control termina

A. The default IP address of the HDMI encoder is 192.168.1.251,your control terminal’s IP must be 192.168.1.xxx for connecting with encoder. “xxx” can be any number ranging from 0 to 255 except 251. Please change your control terminal’s IP to 192.168.1.xxx.
B. You can run CMD, ping 192.168.1.251 on PC,If the connection is successful, the network communication between the PC and the encoder is normal.

How to change the IP address of your control terminal: viewforum.php?f=50

3. Configuration setting

A. Enter “192.168.1.251” in your browser to open the encoder's Web administrator page.
B. Login the configuration interface with the default user name and password as “admin”.
C. Set the configuration of HDMI encoder.

Read the user manual for configuration instructions: viewforum.php?f=40

Tips:
1.If you have changed the IP address of the encoder in the network configuration item, you need to change the IP address of your control terminal to be in the same network segment as the encoder. Then re-login to the the configuration interface via the IP address of the encoder that you have set .
2.If the IP address of the encoder is set to dynamic DHCP, you need to check what IP address the router assigned to the encoder.


How to find the router's IP address assignment:
viewtopic.php?f=50&t=3439

4.Video Streaming

The HDMI encoder supports RTMP/RTMPS for stream to most online video platforms , supports RTSP/UDP protocol multicast and unicast to used for local streaming to computers and decoders.
Streaming setting description link:viewforum.php?f=47

Tips:
1.Local streaming:make sure the encoder, your computers, and decoders are on the same LAN and the IP address is on the same network segment.
2.Live streaming: make sure the IP address of the encoder and the Internet router are in the same network segment ,can connect to the Internet normally.

Post Reply